7 Specifications

7.1 SiteShield

Dimensions: • Length: 8 feet • Width: 4 feet • Height: 18 feet

Weight: • Total Weight: 1700 pounds

Solar Panel Details: • Type of Solar Panels: Monocrystalline • Power Output: 320W • Module Efficiency: 19.2% • Open Circuit Voltage (Voc): 40.10 V • Short Circuit Current (Isc): 10.36 A • Maximum System Voltage: 1000 VDC • Maximum Series Fuse Rating: 15 A • IP Rating: IP68 (1m, 1h) • Dimensions: 65.6 x 39.4 x 1.4 inches (1665 x 1002 x 35 mm) • Weight: 39.7 lbs (18 kg) • Connectors: Solar Connectors, Type 2 • Operating Temperature Range: -40ºF to +185ºF • Nominal Operating Cell Temperature (NOCT): 47±2ºC • Temperature Coefficient of Pmax: -0.44%/ºC • Temperature Coefficient of Voc: -0.30%/ºC • Temperature Coefficient of Isc: 0.04%/ºC

7.2 400 W Solar Panel

Solar Panel Capacity & Type • Module Type: Monocrystalline (or polycrystalline depending on model) • Model / Power Rating: 400 W (peak, STC) • Nominal System Voltage: typically 12 V / 24 V system compatible (check module Vmp/Voc) • Energy Yield: Approximate nominal output at standard test conditions: 400 W × sunlight hours/day (varies by location) Electrical Specifications • Peak Power (Pmax): ~ 400 W • Voltage at Maximum Power (Vmp): e.g., ~ 34 V (varies) • Current at Maximum Power (Imp): e.g., ~ 11.7 A • Open Circuit Voltage (Voc): e.g., ~ 40.5 V • Short Circuit Current (Isc): e.g., ~ 12.6 A • Module Efficiency: Variable; e.g., ~17% in one generic 400 W spec. • Power Tolerance: e.g., 0 % to +3% typical for good modules. • Maximum System Voltage: Often ~1000 V DC (for on-grid modules)

Mechanical / Physical Specs • Dimensions: Example ~ 1722 × 1134 × 30 mm (67.8″ × 44.6″ × 1.18″) • Weight: Example ~ 20.5 kg (≈ 45.2 lbs) • Frame: Anodized aluminium alloy • Front Glass: Tempered, high-transmission low-iron glass (typically ~3.2 mm) • Junction Box & Connectors: Typically IP65 or higher rated for outdoor.

Environmental & Temperature Specs • Operating Temperature Range: Example –40 °C to +85 °C • Nominal Operating Cell Temperature (NOCT): Example ~ 47 °C ±2 °C • Degradation: Many modules guarantee ~90% output at 10 years, ~80% at 25 years. • Mechanical Load Ratings: Example wind + snow loads (IEC 61215 standard) for durability. Certifications / Compliance • IEC 61215, IEC 61730 (common PV module certifications) • CE / ISO9001 etc (depending on manufacturer)

7.3 Battery Charger / Power Converter

Electrical / Output Specifications • Nominal Output Voltage (no load): ~ 13.6 V DC (±0.7%) • Output Voltage at Full Load: > 13.4 V DC • Maximum Continuous Output Current: 45 Amps • Maximum Continuous Power Output: ~ 600 W • Ripple & Noise: < 50 mV rms • Line Regulation: ~100 mV rms • Load Regulation: < 1% • Input Voltage Range (AC): 108–132 VAC for standard model • Input Frequency: 47–63 Hz • Maximum AC Current at 108 VAC: ~ 11 A • Inrush Current (single cycle): ~30 Amps • Typical Efficiency: > 80% Physical / Mechanical • Dimensions: ~ 9.7″ × 6.7″ × 3.4″ (L × W × H) • Weight: ~ 5.0 lbs • Fan: Proportional fan-control (quiet operation) Protection / Features • Reverse polarity fuse protection (external fuse) • Short circuit protection: Yes • Overload / Current limit protection: >100% overload capability • Thermal protection: Yes • Withstand voltage: 1700/1700/500 VDC (line/line/line-to-chassis) Temperature / Environmental • Operating Temperature Range: 0 °C to 40 °C • Storage Temperature: -20 °C to +80 °C Charging Modes / Additional Notes • This unit is a converter/charger — capable of powering 12 V DC loads and charging a 12 V battery bank. • Dual-Voltage Jack: Allows manual selection of a higher charging voltage (e.g., switching from ~13.6 V to ~14.2 V) for faster bulk charging in two-step mode. • Compatible with the optional IQ4 (smart charge controller) module, which upgrades the DLS-45 to four-stage charging (Bulk, Absorption, Float, Equalization) when used.

• Switch-mode technology: Provides clean DC output (beneficial when powering sensitive 12 V loads).

7.4 Battery Capacity and Type

• Battery Type: Sealed Lead Acid, AGM (Absorbent Glass Mat), Valve Regulated (VRLA) • Model: Interstate SLA1189 • Capacity: 100 Ah (20-hour rate) • Nominal Voltage: 12.0 V • Energy: ~1200 Wh (1.2 kWh) • Weight: ~64.9 lbs (29.5 kg) • Dimensions: 12.1 x 6.6 x 8.4 inches (L x W x H including terminals)

Charging Specifications: • Recommended Charge Current: Up to 30 A • Maximum Charge Current: 30 A (to avoid shortened lifespan) • Recommended Charge Voltage (Cyclic Use): 14.4 V – 15.0 V • Recommended Charge Voltage (Float/Standby): 13.5 V – 13.8 V • Charge Mode: CC/CV (Constant Current / Constant Voltage)

Discharge Specifications: • Maximum Continuous Discharge Current: ~100 A (typical rating for 100Ah AGM) • Peak Discharge Current (5 sec): ~1200 A • Standard Discharge Current (20-hr rate): 5 A • Cut-off Voltage: 10.5–10.8 V (standard deep-cycle cutoff)

Efficiency: ~80–85% round-trip (typical AGM efficiency)

Self-Discharge Rate: ~3% per month at 25°C (slower in cooler temps)

Temperature Specifications: • Discharge Temperature: -15°C to 50°C (5°F to 122°F) • Charge Temperature: 0°C to 40°C (32°F to 104°F) • Storage Temperature: -20°C to 40°C (-4°F to 104°F); best stored 10°C to 25°C

7.5 Camera Specifications

7.5.1 Bullet Camera

• Resolution: 2 MP • Field of View: o 9 mm lens: Horizontal 117˚-37˚, Vertical 59˚-20˚ o 29 mm lens: Horizontal 29˚-11˚, Vertical 16˚-6˚ • Minimum Illumination: o 9 mm lens: Color 0.06 lux, B/W 0.01 lux o 29 mm lens: Color 0.06 lux, B/W 0.01 lux • Features: o Lightfinder 2.0 o Forensic WDR o OptimizedIR o Deep learning processing unit for advanced analytics o Cybersecurity features like Axis Edge Vault o IP66/IP67, NEMA 4X, and IK10-rated casing

7.5.2 Pan-Tilt-Zoom (PTZ) Camera

• Resolution: HDTV 1080p • Field of View: Horizontal 58.3˚–2.4˚, Vertical 34.9˚–1.3˚ • Zoom Capability: 32x optical, 12x digital, total 384x zoom • Range: Optimized IR up to 250 m (820 ft) • Minimum Illumination: o Color: 0.06 lux, B/W: 0.008 lux with IR on • Features: o Lightfinder 2.0 o Autotracking 2 and orientation aid o Privacy masking with mosaic o Enhanced security features: signed firmware, secure boot, TPM module o IP66 and NEMA 4X-rated housing

7.6 Additional Components

Two-Way Loudspeaker Integration: The loudspeaker is integrated with the camera unit to provide real-time communication and audio alerts. • Audio Hardware: o Re-entrant horn loudspeaker with compression driver o Maximum Sound Pressure Level: >121 dB o Frequency Response: 280 Hz - 12.5 kHz o Coverage Pattern: 70° horizontal by 100° vertical (at 2 kHz) • Amplifier: o Built-in 7 W Class D amplifier o Digital Signal Processing (DSP): Built-in and pre-configured • Features: o All-in-one speaker system o Connects to standard network o Simple installation with PoE o Remote health testing o Scalable and easy to integrate o Built-in microphone for remote health testing and 2-way communication o Audio streaming: One-way/two-way with optional half-duplex echo cancellation o Audio encoding: AAC LC 8/16/32/48 kHz, G.711 PCM 8 kHz, G.726 ADPCM 8 kHz, Axis µ-law 16 kHz, WAV, MP3 o IP66- and NEMA 4X-rated casing

7.7 Solar Coverage

100 % Night (full IR) 100% Day (no IR) Ambient Temperature -40 to -20 F
-20 to 0 F
<0 F ~X Hours ~X Hours 0 to 25F ~X Hours ~X Hours 25 to 50F ~X Hours ~X Hours >50F ~X Hours ~X Hours *X Hours = hours of operation assuming full battery charge and 0 solar